• 沒有找到結果。

Factors influencing the resonance frequency of dental implants.

N/A
N/A
Protected

Academic year: 2021

Share "Factors influencing the resonance frequency of dental implants."

Copied!
1
0
0

加載中.... (立即查看全文)

全文

(1)

Factors influencing the resonance frequency of dental

implants

葉錦瑩

Huang HM;Chiu CL;Yeh CY;Lee SY;

摘要

Abstract

Purpose: Resonance frequency (RF) analysis has been used by several investigators to assess the boundary conditions of dental implants. However, a scientific investigation of the association between the structural condition of the alveolar bone and the dynamic behavior of dental implants has not yet been reported. The aim of this study was to assess the factors influencing the RF of dental implants using an in vitro modal analysis. Materials and Methods: Resonant vibration within implants was induced by an impulse-force hammer. The induced vibration signal was subsequently detected using an acoustic microphone and analyzed by fast Fourier transform. The resultant data were further analyzed to test the statistical effects of the embedding-material boundary height, thickness, and density on the RF values of the sample implants. Results: Significant changes (P <.05) in RF values were revealed for

implants embedded within a high-density block when decreasing boundary height reached 6, 5, and 4 mm, at respective thickness increments of 10, 15, and 20 mm. For analogous

low-density samples, significant changes (P <.05) in RF values were found when respective decreasing boundary height reached 6, 4, and 3 mm. Conclusions: Our findings indicate that boundary height, width, and density factors can influence the RF of dental implants and that a lower boundary density and greater boundary thickness can lead to more obvious RF

參考文獻

相關文件

The majority of cases of malignancy in conjunction with dental implants in both the literature and the pre- sent series have been of SCC, and most were primary tumors, which is

E ffective utilization of dental and zygomatic implants may help to restore oral function in patients with severe maxillary defects.. This clinical report describes the management

An elementary energy method is introduced in [18] based on a macro-micro decomposition of the equation into macroscopic and microscopic components to analyze the

• Density is varying in the medium and the volume scattering properties at a point is the product of scattering properties at a point is the product of the density at that point

Specifically, we establish three basic properties of the connectivity region – contiguity, monotonicity of the boundary, and uniqueness of the infinite connected component, where

• To the right of the Draw mode buttons you find push buttons through which you can access all the functions that you need to define and solve the PDE problem: define

In the inverse boundary value problems of isotropic elasticity and complex conductivity, we derive estimates for the volume fraction of an inclusion whose physical parameters

Wang, Solving pseudomonotone variational inequalities and pseudocon- vex optimization problems using the projection neural network, IEEE Transactions on Neural Networks 17