• 沒有找到結果。

[PDF] Top 20 EFFECT OF FLUORINE INCORPORATION ON THE THERMAL-STABILITY OF PTSI/SI STRUCTURE

Has 10000 "EFFECT OF FLUORINE INCORPORATION ON THE THERMAL-STABILITY OF PTSI/SI STRUCTURE" found on our website. Below are the top 20 most common "EFFECT OF FLUORINE INCORPORATION ON THE THERMAL-STABILITY OF PTSI/SI STRUCTURE".

EFFECT OF FLUORINE INCORPORATION ON THE THERMAL-STABILITY OF PTSI/SI STRUCTURE

EFFECT OF FLUORINE INCORPORATION ON THE THERMAL-STABILITY OF PTSI/SI STRUCTURE

... Such a highly fluorinated layer acts as a flu- orine-buffer layer to change the PtSi/Si interface energy (and/or the silicide grain boundary energy) which in turn improve[r] ... See full document

10

Moisture resistance and thermal stability of fluorine-incorporation siloxane-based low-dielectric-constant material

Moisture resistance and thermal stability of fluorine-incorporation siloxane-based low-dielectric-constant material

... lifetime, the electrical properties (dielectric constant, breakdown voltage and leakage current ) of interlayeryintermetal dielectric materials were resistant to thermal and moisture ...stresses. ... See full document

7

Effect of deposition temperature, on thermal stability in high-density plasma chemical vapor deposition fluorine-doped silicon dioxide

Effect of deposition temperature, on thermal stability in high-density plasma chemical vapor deposition fluorine-doped silicon dioxide

... for the lower refrac- tive indices. However, as shown in Fig. 1, the RI decreases appreciably with decreasing SiOF film deposition tempera- ture, but with increasing fluorine ...that the lower ... See full document

7

Effect of fluorine flow and deposition temperature on physical characteristics and stability of fluorine-doped siloxane-based low-dielectric-constant material

Effect of fluorine flow and deposition temperature on physical characteristics and stability of fluorine-doped siloxane-based low-dielectric-constant material

... SiCN/OFSG//TaN/Cu/SiO2/Si structure, which OFSG films were prepared under various deposition conditions, was annealed at 500 ° C for seven cycles, each for 1 ...h. The film interface state was ... See full document

7

Effect of adding Ar on the thermal stability of chemical vapor deposited fluorinated silicon oxide using an indirect fluorinating precursor

Effect of adding Ar on the thermal stability of chemical vapor deposited fluorinated silicon oxide using an indirect fluorinating precursor

... position of as-deposited F x SiO y films with various pro- cess temperatures and Ar flow ...that Si–F peak position shifts upward with an increasing deposition tem- perature and Ar flow ...that the ... See full document

4

Thermal stability of Si/Si1 – x – yGexCy/Si quantum wells grown by rapid thermal chemical vapor deposition

Thermal stability of Si/Si1 – x – yGexCy/Si quantum wells grown by rapid thermal chemical vapor deposition

... in the growth 1,2 and characterization 3–6 of Si 1 2x2y Ge x C y alloys, which offer great flexibility in tailoring the strain and the electronic properties of group IV ... See full document

5

Structure and thermal stability of MOCVD ZrO2 films on Si (100)

Structure and thermal stability of MOCVD ZrO2 films on Si (100)

... Abstract The structure and thermal stability of ZrO 2 films grown on Si (1 0 0) substrates by metalorganic chemical vapor deposition have been studied by high-resolution ... See full document

7

The effect of Os interlayers on the thermal stability of magnetic CoFe/OsMn films

The effect of Os interlayers on the thermal stability of magnetic CoFe/OsMn films

... Department of Materials Science and Engineering, National Chiao Tung University, Hsinchu 30010, Taiwan b Laboratory for Spintronics, Electronics and Opto Electronics Research Laboratories, Industrial Technology ... See full document

3

Effects of polyamines on the thermal stability and formation kinetics of DNA duplexes with abnormal structure

Effects of polyamines on the thermal stability and formation kinetics of DNA duplexes with abnormal structure

... Effects of salts and polyamines on the melting temperature of DNA duplexes The T m values of DNA duplexes listed in Figure 1 were deter- mined by recording their A 260 at a ... See full document

8

Effect of Co/Sn doping on the thermal stability of magneticproperties of Ba-ferrite thin films

Effect of Co/Sn doping on the thermal stability of magneticproperties of Ba-ferrite thin films

... The effects of Co/Sn contents and annealing temperature on the perpendicular and in-plane magnetic properties of the Co/Sn doped BaM thin films were also examined[r] ... See full document

3

Effect of Ge incorporation on the performance of p-channel polycrystalline Si1-xGex thin-film transistors

Effect of Ge incorporation on the performance of p-channel polycrystalline Si1-xGex thin-film transistors

... The large amount of trapping states contained at the grain boundaries is essential in influencing the electrical characteristics of polySi films and makes the con[r] ... See full document

7

Effect of hydroxypropyl-b-cyclodextrin complexation on the aqueous solubility, structure, thermal stability, antioxidant activity, and tyrosinase inhibition of paeonol

Effect of hydroxypropyl-b-cyclodextrin complexation on the aqueous solubility, structure, thermal stability, antioxidant activity, and tyrosinase inhibition of paeonol

... Inhibition of tyrosinase The inhibition of tyrosinase by PAE and PAE-HP-b-CD complex was identified by measuring the amount of dopachrome that was generated in the reaction ... See full document

9

IMPROVEMENT OF POLYSILICON OXIDE CHARACTERISTICS BY FLUORINE INCORPORATION

IMPROVEMENT OF POLYSILICON OXIDE CHARACTERISTICS BY FLUORINE INCORPORATION

... 2(a) and (b) shows the J-E characteristics of the polyoxides implanted with different doses of fluorine for the positive top-gate bias (electron injection from the bottom- gat[r] ... See full document

2

The Effect of Surface Stress on the stability of Surface of Stressed Solids

The Effect of Surface Stress on the stability of Surface of Stressed Solids

... THE EFFECT OF SURFACE STRESS ON THE STABILITY OF SURFACES OF STRESSED SOLIDS ...Department of Civil and Materials Engineering, University of Illinois ... See full document

6

Thermal Effect of Surface Tension on the Inward Solidification of Spheres

Thermal Effect of Surface Tension on the Inward Solidification of Spheres

... casting of alloys, and crystallization of pure ...by the existence of a moving interface between different phases at which the thermal energy in the form of latent ... See full document

11

The effects of plasma treatment on the thermal stability of HfO(2) thin films

The effects of plasma treatment on the thermal stability of HfO(2) thin films

... effects of plasma treatment on the thermal stability of HfO 2 thin films Kow-Ming Chang *, Bwo-Ning Chen, Shih-Ming Huang Department of Electronic Engineering and Institute ... See full document

3

The Effect of Patterned Susceptor on the Thickness Uniformity of Rapid Thermal Oxides

The Effect of Patterned Susceptor on the Thickness Uniformity of Rapid Thermal Oxides

... 3-in Si wafers with a resistivity of 1–10 - cm were used as the monitor ...Concentric Si rings were fabricated by chemical wet etching of 4-in Si ...Each Si ring is 3.4 mm ... See full document

5

Effects of Elasticity and Structure of Trabecular Bone on the Primary Stability of Dental Implants

Effects of Elasticity and Structure of Trabecular Bone on the Primary Stability of Dental Implants

... ISQ. The regression correlation coefficient (R 2 ) values between the elasticity of trabecular bone with a cellular (closed-cell) structure and ITV, PTV, and ISQ were ...demonstrate the ... See full document

6

Effect of antimony incorporation on the density, shape, and luminescence of InAs quantum dots

Effect of antimony incorporation on the density, shape, and luminescence of InAs quantum dots

... ing the PL spectra to be dominated by the enormous peak centered at 1100 ...nm. The integrated intensity of this peak is more than three times higher than that of the ground ... See full document

6

Effect of Thermal Annealing on the Surface Properties of Electrospun Polymer Fibers

Effect of Thermal Annealing on the Surface Properties of Electrospun Polymer Fibers

... process. The aspect ratios of the electrospun polymer fi bers are much larger than other one-dimensional polymer materials prepared by methods such as using anodic aluminum oxide tem- ...nozzle. ... See full document

7

Show all 10000 documents...