• 沒有找到結果。

未來研究方向

第五章 模擬結果與分析

6.2 未來研究方向

本論文使用之電子安定器控制器在模擬之測試與預期符合,藉由電子電路 軟體的幫助,可以達成電子安定器電路與控制器的整合模擬,這樣一來,對於 要設計控制器或是已經有控制器電路時,要設計安定器參數時,可以快速的獲 得大概的結果,但模擬與實際電路乃有一段差距,所以未來的研究方向二:

1. 增加安定器調光的功能:

調光式電子安定器在研究上已有不少成果,在市面上也有產品出現。

使用調光安定器,則可以視環境情況,調整燈光的明暗,日光燈則不 會一值操作在滿載功率,進而節省能源。所以若能整合調光控制於控 制電路內,則可以減少安定器電路實現之PCB 面積,也可以減少控制 電路的數量。

2. 將控制電路以晶片實現:

本論文只是先用電路模擬軟體得到一個控制電路之行為模型,接下來 可以繼續研究的方向是將此電路以積體電路(IC)實現。此控制電路 積體化需要高壓製程與混合訊號(Mixed mode signal)電路的設計。

研究步驟為:先找尋有提供高壓製程之半導體廠商,並取得所需製程 之詳細資料,以便進行更精準之模擬。若模擬可行之後,在進行佈局 與下線。另外要注意積體化控制IC 的電路中預期將會大量使用電容,

加上系統中有振盪器設計,故元件耦合電容、雜散電容與寄生電感均 需最小化,否則將造成系統輸出的不穩定性。

參考文獻

[1] 梁適安編譯,高頻交換式電源供應器原理與設計,全華出版社,第四版,

1989 年。

[2] E. E. Hammer, “Fluorescent lamp operating at high frequency,” Journal of the

Illumination Engineering Society, vol. 14, no. 1, pp.211-224, Oct. 1984.

[3] 林昌賢,單晶式螢光燈電子安定器,國立台灣大學電機工程所博士論文,

2000 年 1 月。

[4] 徐瑛瑛,“電子式安定器市場發展機會探討”,工業技術研究院能源與資源 研究所,經濟部ITIS 專題報告,1998 年。

[5] 吳財福,余德鴻,電子安定器綜論,全華出版社,第一版,1997 年 6 月。

[6] “High-Frequency Fluorescent Lamp Ballasts”, American National Standards Institute

,

ANSI C82.11-1993, 1993.

[7] 吳財福,余德鴻,劉原全,單級高功因電子安定器,全華出版社,1997 年 1 月。

[8] 林世宏,電子安定器積體電路之研製,國立清華大學電機工程所碩士論文,

1997 年 7 月。

[9] 吳永駿,電子安定器於低壓氣體放電燈之應用與實務考量,中正大學電機 工程研究所博士論文,2001 年。

[10] J.Ribas, J.M. Alonso, A. J. Calleja, E.L. Corominas, and M.Rico-secades,

“Low-cost high-power-factor electronic ballast based on the self-oscillating buck-boost inverter,” in Proc. IEEE APEC, vol.1, pp.597 – 602, 2000.

[11] Fengfeng Tao, Qun Zhao, F.C. Lee, and N. Onishi, “Self-oscillating electronic ballast withdimming control,” in Proc. IEEE PESC, vol.4, 17-21, 2001.

[12] J. Zhang, M.M. Jovanovic, and F.C. Lee, “Comparison Between CCM Single stage and Two Stage Boost PFC Converters,” in Proc. IEEE APEC, pp. 335-341,

1999.

[13] Fernandez, A. Ferreres, P. Villegas, J. Sebastian, and L. Alvarez, “Size comparison between a half bridge converter with an AICS and a two-stage boost converter operating in a narrow input voltage range,” in Proc. IEEE PESC, Vol. 4, pp.17-21, June 2001.

[14] 沈煌斌,單級單閘高功因電子安定器之研製,台灣大學電機工程研究所碩 士論文,2000。

[15] 梁從主,經濟部工業局九十年度工業技術人才培訓計畫講義,專案計畫名 稱:電機工業人才培訓計畫,課程名稱:HID 電子燈電子式安定器設計與 研製,2001 年 8 月。

[16] 郭彥汛,冷陰極

CCFL

驅動電路設計與分析,交通大學電機與控制工程研 究所碩士論文,2000。

[17] Fengfeng Tao and F.C.Lee, “A critical-conduction-mode single-stage power-factor-correction electronic ballast,” in Proc. IEEE APEC, vol.1, pp.603-609, 2000.

[18] T.-F. Wu, J.-C. Hung, and T.-H. Yu, “A PSpice model for fluorescent lamps operated at high frequencies,” in Proc. IEEE IECON, vol.1, pp.359- 364, Nov.

1995.

[19] Tsai-Fu Wu, Jin-Chyuan Hung, and Te-Hung Yu, “A PSpice circuit model for low-pressure gaseous discharge lamps operating at high frequency,” IEEE

Trans. Industrial Electronics, Vol.44, No.3, pp.428-431, June 1997.

[20] T. Liu, K.J. Tseng, and D.M. Vilathgamuwa, “A PSpice Model for the Electrical Characteristics of Fluorescent lamps,” in IEEE PESC, vol.2, pp.1749-1754, 1998.

[21] S. Ben-Yaakov, M. Shvartsas, and M. S. Glozman, “Statics and Dynamics of

IEEE Trans. Industrial Electronics, vol. 38, Issue: 6, Nov.-Dec. 2002, pp.1486-

1492, 2002.

[22] M. C. Cosby, Jr., and R. M. Nelms, “A resonant inverter for electronic ballast applications,” in IEEE Trans. Industrial Electronics, vol 41, Issue: 4, pp.418-425, Aug. 1994.

[23] 吳財福,余德鴻,吳永駿,調光電子安定器,全華出版社,第一版,1998 年5 月。

[24] N. Mohan, T. M. Undeland, and W. P. Robbins, Power Electronics: Converters,

Applications and Design, John Wiley & Sons, 2003.

[25] J.-S Lai and D. Chen, “Design consideration for power factor correction boost converter operating at the boundary of continuous conduction mode and discontinuous conduction mode,” in Proc. IEEE APEC '93.Conference Proceedings 1993, Eighth Annual, 7-11 March 1993, pp. 267 – 273.

[26] 鄭大森,PSpice 視窗版

:DESIGN CENTER

在電子上的應用,全華出版社,

第二版,2002 年 10 月。

[27] 陳淳杰,從實例中學習

PSpice A/D,儒林圖書出版社,初版,2002 年 12

月。

[28] Cecilia Contenti, and Masashi Sekine. (2002, Nov. 5). “Universal Input Linear Fluorescent Ballast using the IR2166,” International Rectifier, Ref. Design:

IRPLLNR4. [Online]. Available:

http://www.irf.com/technical-info/refdesigns/lnr4.pdf

[29] “PFC & Ballast Control IC,” International Rectifier, Datasheet, 2003. [Online].

Available: http://www.irf.com/product-info/datasheets/data/ir2166.pdf

[30] F. Li, D. Giannopoulos, and I. Wacyk, “A low loss high-frequency half-bridge driver with integrated power devices using EZ-HV SOI technology,” in Proc.

IEEE APEC, vol.2, pp.1127 – 1132, 2002.

[31] Nicola Tricomi. (1997). “Low Cost Active Clamp For Hign Frequency Applications,” ST Microelectronics, Application notes: An881/1297, [Online].

Available:

http://www.eetasia.com/ARTICLES/2000JUN/2000JUN16_AMD_AN9.PDF [32] “MASTER TL5 High Efficiency,” Royal Philips Electronics, datasheet, 2004.

[Online]. Available:

http://www.eur.lighting.philips.com/int_en/oem/ca/general/products/catalogue/c hapterpages/fluo.html

[33] Charles K. Alexander and Matthew N. O. Sadiku, Fundamentals of Electric

Circuits, McGraw-Hill Book Co, 2000