[PDF] Top 20 Influence of annealing temperature on the structural, optical and mechanical properties of ALD-derived ZnO thin films

... examine the surface morphology of the samples. For the AFM operation, a constant scan speed of 1 ␮m/s was used, with a con- stant load of 30 nN being applied to the ... See full document

... once the structural defects formed at the low-T ph , they cannot be annihilated by the next post-annealing ...For the film with T ph ¼500 1C, the SD-transitions disappear ... See full document

... The influence of annealing on the AgGaS films grown by pulsed laser deposition has been ...investigated. The X-ray diffraction 2 results show the AgGaS ... See full document

... sapphire. The growth temperature of the p-GaN thin films was set at 1100  ...C. The concentration of Mg doping was controlled by varying the flow rate of ... See full document

... monitoring the electric and optical properties through careful control of the processing parameters, successful fabrication of devices based on Ga-doped ZnO ... See full document

... 1C, the islands formed came closer to each other, with the larger ones appearing to grow by coalescence of smaller ...Thus, the surface structure of films became denser and ... See full document

... Keywords ZnO
PLD
AFM
Nanoindentation
Nanoscratch
Hardness Introduction ZnO semiconductor, having a wide direct band gap of ...room temperature, has attracted much attention because ... See full document

... investigates the effects of Cr buffer layers and post-annealing on the properties of titanium- doped zinc oxide (TZO) thin films prepared by radio frequency ... See full document

... Al-doped ZnO thin films have been prepared by the well-established sol–gel technique under suitable thermal ...treatment. Structural, electrical, and optical properties ... See full document

... “Mechanisms of green emission from ZnO films prepared by rf magnetron sputtering,” Optical Materials, ...Kim, and S. Im, “Effects of post- annealing treatment on ... See full document

... discussed the effects of annealing time on the structural and optical properties of sputtered ZnO ...treatment, the annealed ZnO ... See full document

... combination of XRD, AFM and nanoindentation techniques has been carried out to investigate the structural, surface morphological features, and nanomechanical properties of ... See full document

... from the Nd-YAG fourth-harmonic laser. The laser beam was focused onto the target with an incident angle of 45 and the fluence on the ZnO nanorods was ... See full document

... Department of Electronics Engineering and Institute of Electronics, National Chiao-Tung University, Hsinchu 300, Taiwan, ROC Available online 14 September 2006 Abstract A systematic study of ... See full document

... Department of Materials Science and Engineering, National Cheng Kung University, Tainan 701, Taiwan Received 24 February 2006; received in revised form 26 March 2006; accepted 29 March 2006 Abstract ... See full document

... Conclusion The PLD deposited ZnO thin films formed at the constant partial pressure of a N 2 O atmosphere at various substrate temperatures revealed different ferromagnetic ... See full document

... (BZO) thin films have been fabricated by spray pyrolysis on a glass ...substrate. The morphology and electrical properties of the thin films were ... See full document

... between the AFM and the SCM images is ...exclude the correlation is due to topographic effect on the capacitance signals since the root-mean-square surface roughness is ... See full document

... form and embed in GZO grains (as shown in Fig. 3). It could increase the barrier height between the GZO grain bound- aries and reduce the conductivity of GZO poly-crystal ... See full document

... Therefore, the peak intensity of NBE emission was slightly enhanced by the implantation of nitrogen ...for the same lower N-implanted concentration, ...in the N-implanted ... See full document