[PDF] Top 20 Scanned probe oxidation on p-GaAs(100) surface with an atomic force microscopy
Has 10000 "Scanned probe oxidation on p-GaAs(100) surface with an atomic force microscopy" found on our website. Below are the top 20 most common "Scanned probe oxidation on p-GaAs(100) surface with an atomic force microscopy".
Scanned probe oxidation on p-GaAs(100) surface with an atomic force microscopy
... anodic oxidation has been performed to fabricate the nanoscale oxide structures on p-GaAs(100) surface, by using an atomic force microscopy (AFM) with ... See full document
6
Localized electrochemical oxidation of p-GaAs(100) using atomic force microscopy with a carbon nanotube probe
... 6 Author to whom any correspondence should be addressed. quantum interference devices (SQUIDs) [4]. In addition, the parallel writing technique based on arrays of AFM probes has been recently developed [5, 6] for ... See full document
7
Surface roughness measurement on microchannels by atomic force microscopy using a bent tapered fiber probe
... bent probe was fabricated by a combination of laser heating-pulling 12 and electric arc ...fiber probe from a 125 m telecommu- nication single mode optical fiber 共SMV130, Prime Optical Fiber Corporation, ... See full document
3
Mechanisms of p-GaAs(100) surface by atomic force microscope nano-oxidation
... at an indentation depth of ...at an indentation depth of ..., GaAs and tip-induced GaAs ...tip-induced GaAs oxides exhibit larger hardness values than other semiconductor materials, ... See full document
10
Theoretical and experimental studies for nano-oxidation of silicon wafer by ac atomic force microscopy
... its surface voltage were measured on a scanning probe microscope 共SPM, SPA 300HV, Seiko兲 by using its two ...the force-displacement profiles which were produced before and after applying a ... See full document
11
Nano-oxidation of silicon nitride films with an atomic force microscope: Chemical mapping, kinetics, and applications
... local oxidation of silicon nitride films deposited on conductive substrates with a conductive-probe atomic force microscope 共AFM兲 is a very promising approach for ...Auger ... See full document
9
Atomic-scale epitaxial aluminum film on GaAs substrate
... semi-insulating GaAs (001) substrate, a 200-nm-thick undoped GaAs buffer layer was grown at 580 o C ...The GaAs surface was then heated to 600 o C with no arsenic flux for 3 minutes to ... See full document
7
Surface analysis of nanomachined films using atomic force microscopy
... direct atomic and molec- ular manipulation [6]; (3) direct cutting of the material ...nanodevices. An AFM probe is com- monly used to scratch a fine groove or hole in a soft metal or polymer ... See full document
2
Surface ultrastructure of SARS coronavirus revealed by atomic force microscopy
... Summary Atomic force microscopy has been used to probe the surface nanostructures of severe acute respiratory syndrome coronavirus ...treatment with hydroxyoctanoic ...the ... See full document
8
Effect of gold coating on local oxidation using an atomic force microscope
... Local oxidation using an atomic force microscope 共AFM兲, or AFM nano-oxidation, is a promising scanning- probe-based lithography method suitable for fabrication of nanometer scale ... See full document
3
In-Plane Gate Transistors Fabricated by Using Atomic Force Microscopy Anode Oxidation
... Si-doped GaAs capping layer, a 15-nm Si-doped Al ...grown on a semi- insulating GaAs ...n-type GaAs and Al ...undoped GaAs/Al ...mesa with a width/depth of ...electrodes ... See full document
3
Elasticity and nanomechanical response of Aspergillus niger spores using atomic force microscopy
... scanning probe microscope system (NT- MDT SFC050L) was ...conductive probe with a tip radius of 20 nm. A constant nor- mal force of 5 nN was maintained between the tip and the sample ... See full document
3
Nanoscale surface electrical properties of indium-tin-oxide films for organic light emitting diodes investigated by conducting atomic force microscopy
... existed on sample C, but not on samples A and ...light on issues related to OLED efficiency and ...consistent with a recent study that connects the WF increase to the oxidation of ... See full document
5
The fabrication of nanomesas and nanometal contacts by using atomic force microscopy lithography
... INTRODUCTION Atomic force microscopy lithography 共AFML兲 has be- come a promising tool to fabricate electronic and optoelec- tronic devices in nanometer scale in recent ...local an- odic ... See full document
6
Atomic force microscopy: Determination of unbinding force, off rate and energy barrier for protein–ligand interaction
... unbinding force (i.e. rupture force) of protein–ligand interactions can be measured by employing the force–distance curve of the ...substrate surface and the ligand bound to the AFM ... See full document
16
Novel Three-Dimensional Beam Tracking System for Stationary-Sample-Type Atomic Force Microscopy
... attached on a 51-g brass block, which is used to simulate a heavy ...the probe, the objective lens, and the lens ...taken with different scanning speeds clearly indicate that the secondary z scanner ... See full document
7
Direct visualization of triplex DNA molecular dynamics by fluorescence resonance energy transfer and atomic force microscopy measurements
... environment with the MPF-3D 共Asylum Re- search, Santa Barbara, CA兲 in tapping ...the probe and the coverslip affect the force curve during the process of probe withdrawal from the coverslip, ... See full document
4
Methods of determining the contact between a probe and a surface under scanning electron microscopy
... electron microscopy 共SEM兲 has gone through a long way to bring us a versatile tool for microscopic ...gain an increasing attention from the community of both nanoscience and ...2 On the one hand, ... See full document
8
Atomic force microscopy study on the surface structure of oxidized porous silicon
... The AFM image shows the PS surface with a self-affine random fractal structure of wires, hillocks and voids in various scales.. After oxidization the wires and hill[r] ... See full document
4
Oxidation characteristics of nanodot and nanobump on TiN thin films by atomic force microscopy
... particular, an AFM-based local anodization process has been investigated for the fabrication of nanostructures and nanodevices ...[3,4]. Atomic layer chemical vapor deposition (ALCVD) is a promising ... See full document
2
相關主題